In some situations you may want to automatically split the entered time into a standard rate and an overtime rate. For example, you might want to configure:
- If a contractor works more than 8 hours in a day, split 8 hours onto a standard rate and the rest onto an overtime rate
- If a contractor works more than 40 hours in a week, split 40 hours onto the standard rate and the remainder onto the overtime rate
These rules can be configured on a per-placement or per-client basis.
Restrictions
This facility is only available to clients who have purchased the Time Patterns and Filters Module
Configuring a Week-Based Rule
In this example a week-based overtime rule is created. The rule requires that placements have specific rates, one for standard hours and one for overtime hours. These rates must have the same name for all placements to which the rule should apply. In this example,
- Time would be entered on the rate called Standard
- Regular time would be paid on the rate called Standard
- Overtime would be paid on the rate called Overtime
- The number of hours after which overtime is paid is 40.
To configure the rule, locate the client from the Profiles->Clients page. After navigating to the client details page, client the Filters tab.
From the drop-down choose "Replace 'pot' rate value based on weekly threshold" and click Add as shown below
Then enter the following information:
- Pot Rate Name: Standard
- Threshold: 40
- Over Rate Name: Overtime
- Under Rate Name: Standard
Applicable When should be left blank
The timesheet is then entered using the standard timesheet entry as shown below